Overhead view of a gray residential air conditioning condenser unit mounted on a concrete pad beside a house with asphalt shingle roofing.

AC Repair in Torrington, WY

Air conditioners here run from July through August. If yours quits, tell us what it's doing and a licensed contractor who covers Goshen County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
Aerial view of a gray central air conditioning condenser unit on a concrete pad next to a house with vinyl siding.

Torrington asks a lot of an AC in a short season

Your air conditioner in Goshen County only has two months, July and August, to do its job, and it has to do it hard. Afternoons averaging 85°F mean the compressor is running at full load most of the day, not cycling lightly. A unit that sits idle ten months a year and then gets pushed hard for two is more likely to show a weak capacitor or a low refrigerant charge right when you need it most.

The bigger risk here comes from the sky, not the heat. Goshen County has logged 183 hail events and 76 damaging wind events over the past ten years, with hail up to 4.5 inches recorded. That kind of hail bends the thin aluminum fins on your outdoor coil, and bent fins block airflow, which makes the system work harder and cool less. Wind that strong can also rock the unit on its pad or throw debris into the cabinet. If your AC is cooling worse than it used to, or making noise it didn't before, a storm may be the reason.

2 months
July through August, your air conditioner is on duty
85°F
the average summer afternoon it cools against
183 hail events
in ten years, and hail bends the fins on outdoor coils
76 wind events
in ten years, and wind drives debris into outdoor units
Isometric cutaway illustration of a small house showing interior rooms with furniture, an indoor air handler with ducts in the attic space, and refrigerant lines running to an outdoor condenser unit on a pad.
Your air conditioner works hardest from July through August.

NOAA nClimDiv, 1991–2020 normals

Aerial view of a residential air conditioning condenser unit mounted on a concrete pad next to a house with vinyl siding and a sliding glass door.

A new air conditioner would save little on running costs in Goshen County, so the repair decision comes down to the unit's condition.

  • A new one at the federal minimum, 13.4 SEER2$230 a year
  • An older air conditioner$250 a year

Estimates for a typical Goshen County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Wyoming fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when a part like a capacitor or contactor has failed.

Replacement makes sense when the compressor has failed or the system uses R-22 refrigerant, which is no longer made.

Why is my AC not blowing cold air?
The most common cause is a dirty air filter choking off airflow across the coil, which can let it ice up. Low refrigerant from a leak is another common cause, and it will not fix itself by adding more, since the leak has to be found and sealed. If the outdoor unit is not running at all while the indoor blower is, the compressor or a capacitor may be the problem. Check the filter first, and if it is clean, a contractor will need to check refrigerant levels and the outdoor unit.
Why is my AC leaking water?
Most of the time this means the condensate drain line is clogged, so the water that normally drips away backs up and finds another way out. Algae and dust build up in that line over a cooling season and block it. A frozen coil that then thaws can also dump more water than the drain pan and line are handling at once. Turning the system off lets any ice melt, but the drain line still needs to be cleared to stop it happening again.
Why won't my AC turn on?
Start with the thermostat, since dead batteries or a setting bumped above room temperature will stop the system from calling for cooling. Check the breaker next, because a tripped breaker cuts power to the whole unit. If power and settings both look right, the problem is likely inside the unit, in the capacitor, the contactor, or the control board, and that needs a contractor to diagnose.