HVAC Repair in Pinedale, WY
If your system quits, tell us what it's doing and a licensed contractor who covers Sublette County will get in touch.
Tell us about the job
It takes about a minute.
Your furnace runs every month here
Pinedale doesn't give the furnace a break. Winter nights average 4°F from December through February, and summer afternoons only reach 73°F, so the furnace carries the house all year. That kind of run time wears on the parts that make heat. The igniter fails after enough cycles. The blower motor wears down from constant use. When one goes, there's no stretch of mild weather to wait it out in.
Sublette County also sees hard weather that tests the system further. The last ten years brought 281 winter storms and 65 damaging wind events. Storms like that knock out power, and in Wyoming about 8% of households lost power for a full day or more in 2024. Most furnaces need electricity to run the blower and ignition even on gas heat, so when the power goes out, the furnace stops with it. It should start again once power is back. If it doesn't, that's a sign something needs a look.
- 4°F
- the average winter night it heats against
- 73°F
- the average summer afternoon it cools against
A new furnace and air conditioner would cut about $190 a year off heating and cooling for a typical Sublette County home.
Estimates for a typical Sublette County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Wyoming fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
- Why is my heat not working?
- Start with the thermostat. Make sure it is set to heat and the temperature is set above the room temperature, since a setting bumped by accident is more common than it sounds. If the thermostat looks right, check the breaker for the furnace and the switch that looks like a light switch near the unit, since that shuts it off for service and gets left off by mistake. Gas furnaces also need the pilot lit or the igniter working, and a pilot that will not stay lit or an igniter that will not glow usually means a contractor needs to look at it. With winter nights here averaging 4°F, a furnace that will not run is not something to leave for later.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and when that happens the coil can freeze up and stop cooling the air even though the system keeps running. If the filter is clean, look at the outdoor unit and clear away any leaves, grass clippings or anything blocking the sides of it, since it needs open airflow to move heat outside. If both of those look fine and the house still is not cooling, the system likely needs a contractor to check the refrigerant charge or the coil itself.
- What can I check before calling for HVAC repair?
- Check the thermostat settings, the batteries in it if it uses any, and the breaker for the system. Those catch a surprising number of no-heat and no-cool calls before they start. Also check the air filter, since a filter packed with dust chokes off airflow and can cause problems that look like something bigger. Winter storms and wind events are common here, so if the system stopped working during or right after one, check the breaker again, since a power blip can trip it even after the lights come back on. If none of that brings it back, a contractor will need to diagnose it directly.