A snow-covered suburban house at dusk with one illuminated window and a double garage door.

Furnace Installation in Gillette, WY

A new furnace here will run from September through June every year. Tell us about the house, and a licensed contractor who covers Campbell County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement containing a gas furnace with ductwork in the foreground and miscellaneous stored items along the far concrete wall.

Ten months of heat a year asks a lot of a furnace

In Gillette, furnaces run September through June. Winter nights average 13°F, and that means long hours of steady work for a new system, not just a few cold snaps to get through.

More than half the homes here heat with gas, and any non-weatherized gas furnace built since November 2015 has to reach at least 80 percent AFUE. Power matters too. Wyoming saw 8% of households lose power for 24 hours or more in 2024, and this county has logged 49 winter storms and 202 damaging wind events over the past ten years. A new furnace here needs to hold up through the season and through what the weather does along the way.

10 months
September through June, your furnace is on duty
13°F
the average winter night it heats against
53%
of homes here heat with gas, so most furnaces here burn gas
80% AFUE
the federal minimum any new unit must meet
Isometric cutaway illustration of a single-story house showing interior rooms with furniture, a furnace unit connected to ductwork and a tall flue pipe extending through the roof.
Your furnace works hardest from November through April.

NOAA nClimDiv, 1991–2020 normals

A gray forced-air furnace with sheet-metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a hanging incandescent bulb.

A high-efficiency gas furnace would save about $110 a year to run in Campbell County compared with a gas furnace.

  • A high-efficiency gas furnace$560 a year
  • A gas furnace$670 a year

Estimates for a typical Campbell County home, from EIA household energy data, Wyoming fuel prices and NOAA climate normals. Your home will differ.

What size furnace does my house need?
The right size comes from a load calculation, not a guess based on square footage. A contractor measures your walls, windows, insulation, and ceiling height, then figures out how much heat your house actually loses on a cold night. That matters more here than in milder places, since winter lows average 13°F and the furnace has to keep up with that for ten months a year. Too big and it short cycles, too small and it runs constantly without catching up. Ask the contractor to walk you through the calculation rather than just quoting a number.
How do I know it's time to replace my furnace?
Watch for uneven heat, rising bills for the same amount of use, or repairs that keep coming back. An older furnace is worth a second look too, especially in a place where the furnace runs nearly all year, September through June. If yours is struggling to keep the house warm when it's 13°F outside, that's a sign it's losing ground, not just having an off night. A contractor can tell you whether the unit is worth repairing again or whether replacement makes more sense at this point.
Is a high-efficiency furnace worth it?
It depends on how much you heat and how long you plan to stay in the house. Since homes here need heat from September through June, a furnace is doing a lot of work over the year, so the efficiency rating has more chance to matter than it would somewhere with a short winter. Every non-weatherized gas furnace built since November 2015 has to hit at least 80 percent AFUE, so even a standard model isn't wasteful, but higher-efficiency units push that further. A contractor can lay out the AFUE options for your situation and let you weigh the difference yourself.