HVAC Installation in Gillette, WY
A new system here will heat from September through June and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Campbell County will get in touch.
Tell us about the job
It takes about a minute.
A furnace built for ten months of winter
Gillette needs heat from September through June. That is ten months out of twelve, and on the nights that drop to 13°F on average, a furnace runs long and often to hold the house steady. Whatever goes in has to handle that stretch, not just a few cold nights here and there.
Summer asks less of the system. Afternoons average 83°F in July and August, so the air conditioner only has two months to earn its place, but it still needs to be sized right for them. Campbell County has seen 49 winter storms and 202 damaging wind events over the last ten years, and in 2024, 8% of Wyoming households lost power for a day or more. A new system should be able to come back on by itself once the power does.
- 10 months
- September through June, your system heats
- 2 months
- July through August, it cools
- 13°F
- the average winter night it heats against
- 83°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
- When should I replace my HVAC system?
- Replace it when repairs start costing more than they're worth or when the system can no longer keep up. An older furnace or air conditioner that needs frequent repairs is a sign the equipment is wearing out, not just having a bad year. With heat needed here September through June, a furnace working that hard for ten months a year sees more wear than one in a milder place. If a contractor is recommending another repair on an older unit, ask what a new system would cost instead.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together often makes sense, but it depends on the condition of each. A furnace and air conditioner installed at the same time are matched to work together, which can affect efficiency and how evenly the system heats and cools. If one unit is still fairly new, a contractor can tell you whether it will pair well with a new counterpart or whether replacing just one is the better move. Since homes here run the furnace far more than the air conditioner, September through June against just July and August, the furnace's condition usually matters more to the decision.
- What happens during an HVAC installation?
- A contractor removes the old equipment, then sets the new furnace, air conditioner, or both in place and connects them to the ductwork, gas line or electrical circuit, and thermostat. They check the ducts for leaks or sizing problems, since even a good new unit won't heat or cool well through bad ductwork. Once everything is connected, they test the system, check refrigerant levels if there's an air conditioner involved, and confirm it's heating or cooling correctly before they leave. The exact steps and how long it takes depend on the equipment and the house, so a contractor can walk you through what your installation will involve.