HVAC Installation in Jackson, WY
Tell us about the house, and a licensed contractor who covers Teton County will get in touch.
Tell us about the job
It takes about a minute.
Step 1 of 3: Equipment
A system that has to run all year here
Winter nights average 8°F from December through February, and a new furnace or heat pump has to hold the house against that for months at a stretch. There is no season off. Summer afternoons average just 69°F, so cooling barely enters into it, but heat is needed all twelve months of the year.
Most homes here run on electric heat, which ties the system to the power grid. Wyoming saw 8 percent of households lose power for at least 24 hours in 2024, and this area has logged 203 winter storms over the past ten years. Whatever gets installed should keep working, or fail safely, on the night the power goes with it.
- 8°F
- the average winter night it heats against
- 69°F
- the average summer afternoon it cools against
- When should I replace my HVAC system?
- Replace it when repairs start happening every year or the system can no longer keep the house warm. Furnaces here run all 12 months, so a unit that struggles to keep up will only get worse as winter goes on. If a contractor tells you the heat exchanger or the blower motor is going, that is usually the point where replacing makes more sense than repairing again. A system that cannot hold up through an 8°F night is not one to gamble on.
- Should I replace my furnace and air conditioner at the same time?
- Homes here need cooling zero months a year, with summer afternoons averaging 69°F, so the two units are not working under the same demands. The furnace does nearly all the work, every month of the year. If the air conditioner is still running fine, there is little reason to replace it early. Put the attention and the decision on the furnace, since that is the equipment actually keeping the house livable through the winter.
- What happens during an HVAC installation?
- A contractor removes the old furnace or system and sets the new one in its place, then connects it to the existing ductwork, gas line or electrical circuit, and venting. After that they test it, checking that it ignites properly, reaches the right temperature rise, and shuts off the way it should. With 67.3% of homes here heating with electricity, a lot of installations also involve checking that the electrical circuit can handle the new unit. A contractor walking the specific house will know what that job needs.