HVAC Installation in Wheatland, WY
A new system here will heat from September through May and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Platte County will get in touch.
Tell us about the job
It takes about a minute.
Nine months of heat, two months of real summer
Winter nights average 16°F from December through February, and homes here need heat from September through May, 9 months a year. Summer is shorter but still asks something of the system, with afternoons averaging 84°F through July and August. Between the two, a furnace or air conditioner here is doing real work 11 months out of the year.
A new system installed in Wheatland has to be sized for both ends of that stretch, the long cold season and the short hot one, not just whichever is on your mind when you call.
- 9 months
- September through May, your system heats
- 2 months
- July through August, it cools
- 16°F
- the average winter night it heats against
- 84°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
- When should I replace my HVAC system?
- Replace it when repairs start becoming frequent or a major part like the heat exchanger or compressor fails, rather than waiting for a total breakdown. An aging system also tends to lose efficiency even while it still runs, so higher bills are often a sign worth paying attention to. Homes here need heat from September through May, so a furnace that struggles in fall will only get worse once the cold nights of winter arrive. If your system is old and a contractor is already out for a repair, ask them to check its overall condition before you spend money fixing something near the end of its life.
- Should I replace my furnace and air conditioner at the same time?
- It depends on the age and condition of each unit, not on doing them as a pair out of habit. If both are original to the house and close in age, replacing them together lets a contractor size the new system properly and match the furnace blower to the air conditioner coil. But if one is much newer, there is no reason to replace it early just because the other failed. A contractor can look at both and tell you honestly whether pairing them makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace and or air conditioner in place, and connects it to the existing ductwork, gas line, refrigerant lines, and electrical. They test the system afterward, checking things like gas pressure, refrigerant charge, and airflow to make sure it runs the way it is supposed to. The job also usually includes sealing up connections and checking the vent hood or flue on a gas furnace. A contractor can walk you through what your specific installation will involve, since it depends on the equipment and the layout of the house.