A white wall-mounted split-system air conditioner on a blue-grey wall, with a full moon visible through a curtained window at night.

Mini Split Installation in Evanston, WY

Tell us about the house, and a licensed contractor who covers Uinta County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A dark, minimalist bedroom with a king-size bed, wall-mounted air conditioning unit, and large windows, with a cat sleeping on the duvet.

Ten months of heat, down to 10 below

Evanston needs heat from September through June. Ten months a year, your mini-split is the thing standing between you and a cold house. Winter nights average 10°F, and it has to keep pulling heat out of that cold air every one of those nights.

A mini-split installed here should be rated for real cold weather performance, not just the mild afternoons. Any unit manufactured from 2023 on has to meet 7.5 HSPF2 for heating, but in a place that runs this cold this long, the difference between a unit built for mild winters and one built for this one shows up fast. Summers stay mild here, averaging 76°F, so the load on the system runs almost entirely on the heating side.

10 months
September through June, your system heats
10°F
the average winter night it heats against
76°F
the average summer afternoon it cools against
Isometric cutaway illustration of a gray house showing two wall-mounted indoor air conditioning units in separate rooms with furniture, connected by line sets to an outdoor condenser unit on a pad outside.
Is a mini split worth it?
For most homes here, yes, especially if a room or addition never gets warm enough from the main system. Evanston winters average 10°F at night from December through February, and a mini split with a good low-temperature rating can still pull heat from that cold air. Homes here need heat or cooling 10 months a year, so a unit that covers a problem room or a whole house well can see steady use. A contractor can look at your gas furnace setup and tell you whether a mini split makes sense as backup, supplement, or main heat.
How many rooms can a mini split cover?
A single indoor unit is built for one room or one open area. If you need to cover several rooms, you install a multi-zone system, which runs one outdoor compressor to multiple indoor heads, each with its own thermostat. How many zones a house can support depends on where the outdoor unit can sit and how the rooms are laid out, so a contractor sizing the job will walk the house first.
Can a mini split heat a whole house?
It can, if it is sized and placed for the whole house rather than dropped into one room. That means a multi-zone system with enough indoor heads to reach every part of the house, and outdoor equipment rated to keep working at 10°F, which is the average winter low here. Most homes here still lean on gas heat, so a mini split is often added as the main system for part of the house or as backup for the coldest nights. A contractor can run the heat loss numbers for your house and tell you what full coverage would take.